Looking closer at Figure 3.1 you will note the line: CentralMgmt.CMSMaster: } PS C:\Get-CsBackupServiceStatus -PoolFqdn “” | Select BackupModules | fl Figure 3.1: Backup Modules Output To expand to see the BackupModules you can run the command as: Output of the above command is: Figure 3: Primary Backup Status Output PS C:\Get-CsBackupServiceStatus -PoolFqdn “” In order to do this run the following command: Now check to make sure there are no issues with the backup state of the environment. To ensure the service level information has been loaded correctly. Once the above is done, rerun the command: Run the command for each standard edition server. Note: Please replace “” with your own server FQDN. PS C:\New-CsRegistrarConfiguration -Identity service:Registrar: -EnableDHCPServer $true -PoolState $true If incase you do not have the additional service level registrar’s pointing to the Frontend’s please run the following command: Output of the above command is: Figure 2: Registrar Output “C:\Users\\AppData\Local\Temp\2\Invoke-CsPoolFailOver-6fd7e68f-01a8-412d-90b4-76326cbc4d66.html”.įirst run the following command in Skype Management Shell: WARNING: Detailed results can be found at (2) and warnings (0) are addressed before continuing. Consult the log file for a detailed analysis, and ensure all errors WARNING: Invoke-CsPoolFailOver encountered errors. FullyQualifiedErrorId : .InvokePoolFailOverCmdlet CategoryInfo : InvalidResult: (:), ManagementCOMException Only on servers running Lync Server 2013 or later.Īt .InvokePoolFailOverCmdlet.Action() Invoke-CsPoolFailOver : .ManagementCOMException: Version check failed. WARNING: Cannot find “RegistrarConfiguration” “Registrar:” because it does not exist. Get-CsRegistrarConfiguration -Identity ‘service:Registrar:’ Yes Yes to All No No to All Suspend Help (default is “Y”): Or any disabled services can delay (or in some cases result in unsuccessful) fail over operations. Please check that the pool is healthy as conditions such as high CPU, low available memory The diagram below shows the layout of the environment where the DR was carried out on: Figure 1 – Environment Overviewīefore proceeding to test DR you need to make sure the appropriate registrar information is available/configured in the environment otherwise you will get the following error during Pool Failover process: The article takes you through step by step of carrying out both health check and invoking disaster recovery (DR) a standard edition environment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |